DTC P0500: Vehicle Speed Sensor [07/2020 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Engine / Data List / Primary / Vehicle Speed.

   Powertrain > Engine > Data List 

   Tester Display
   Vehicle Speed

5. Drive the vehicle.
6. Read the value displayed on the Techstream.

   Result

   Result	Proceed to
   Values displayed on Techstream and speedometer display not equal	A
   Values displayed on Techstream and speedometer display equal	B

Result: 

B 

CHECK FOR INTERMITTENT PROBLEMS. Refer to  CHECK FOR INTERMITTENT PROBLEMS [07/2020 - ] 

Result: 

A 

See step  2

1. Disconnect the combination meter assembly connector.
2. Disconnect the ECM connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   P25-19 (+S) - A58-44 (SPD)	Always	Below 1 Ω

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  3

1. Check the circuits that send vehicle speed signals to this system in the combination meter system.

   Refer to Speed Signal Circuit [07/2020 - 05/2023] , or refer to Speed Signal Circuit [05/2023 - ]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  4

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Clear the DTCs.

   Powertrain > Engine > Clear DTCs 

5. Turn the engine switch off and wait for at least 30 seconds.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  5

1. Drive the vehicle in accordance with the driving pattern described in the Confirmation Driving Pattern.
2. Enter the following menus: Powertrain / Engine / Trouble Codes.

   Powertrain > Engine > Trouble Codes 

3. Read the DTCs.

   HINT: 

   If no DTCs (no pending DTCs) are output to the Techstream, the repair has been successfully completed.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

END