Headlight Cleaner Switch Circuit [08/2015 - 08/2019]: Procedure

1. Remove the headlight cleaner switch assembly (Refer to INSPECTION [08/2015 - ] ).
2. Inspect the headlight cleaner switch assembly (Refer to INSPECTION [08/2015 - ] ).

Result: 

NG 

REPLACE HEADLIGHT CLEANER SWITCH ASSEMBLY 

(Refer to REMOVAL [08/2015 - ] )

Result: 

OK 

See step  2

1. Disconnect the G54 headlight cleaner switch assembly connector.
2. Disconnect the A32 headlight cleaner control relay connector.
3. Remove the main body ECU (multiplex network body ECU) (Refer to REMOVAL [08/2015 - 08/2019] ).
4. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   G54-8 - A32-2 (H)	Always	Below 1 Ω
   G54-8 or A32-2 (H) - Body ground	Always	10 kΩ or higher

5. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   G54-5 or A-15 (HRLY) - Body ground	Always	11 to 14 V

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE 

(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - ] )

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR