Steering Pad Switch Circuit [08/2019 - 08/2021]: Procedure

1. Remove the steering pad switch assembly (Refer to REMOVAL [08/2019 - ] ).
2. Inspect the steering pad switch assembly (Refer to INSPECTION [08/2019 - ] ).

Result: 

NG 

REPLACE STEERING PAD SWITCH ASSEMBLY 

(Refer to REMOVAL [08/2019 - ] )

Result: 

OK 

See step  2

1. Remove the spiral cable sub-assembly (Refer to REMOVAL [08/2019 - ] ).
2. Inspect the spiral cable sub-assembly (Refer to INSPECTION [08/2019 - ] ).

Result: 

NG 

REPLACE SPIRAL CABLE SUB-ASSEMBLY 

(Refer to REMOVAL [08/2019 - ] )

Result: 

OK 

See step  3

1. Disconnect the H11 multi-media module receiver assembly connector.
2. Disconnect the G107 spiral cable sub-assembly connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Switch Condition	Specified Condition
   H11-30 (SW1) - G107-6 (AU1)	Always	Below 1 Ω
   H11-31 (SW2) - G107-5 (AU2)	Always	Below 1 Ω
   H11-32 (SWG) - G107-3 (EAU)	Always	Below 1 Ω
   H11-30 (SW1) - Body ground	Always	10 kΩ or higher
   H11-31 (SW2) - Body ground	Always	10 kΩ or higher
   H11-32 (SWG) - Body ground	Always	10 kΩ or higher

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE 

(Refer to PROBLEM SYMPTOMS TABLE [08/2019 - 08/2021] )

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR