Installation [08/2020 - ]: Procedure

for UA80E: Refer to PROCEDURE - Step 1

for P710: Refer to PROCEDURE - Step 1

for UB80F: Refer to PROCEDURE - Step 1

for UA80E: Refer to PROCEDURE - Step 2

for P710: Refer to PROCEDURE - Step 2

for UB80F: Refer to PROCEDURE - Step 2

1. Engage the pin to install the No. 1 steering wheel ornament.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Install the 2 screws.

See step  1

See step  1

Refer to PROCEDURE - Step 9 [08/2020 - 09/2022] , or refer to PROCEDURE - Step 9 [09/2022 - ]

1. Align the matchmarks on the steering wheel assembly and steering main shaft to install the steering wheel assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a

   Matchmark

2. Using a 10 mm hexagon socket wrench, install the steering wheel assembly set bolt.

   Torque: 62 N.m (632 kgf/cm, 46 ft.lbf) 

3. Connect each connector to the spiral cable with sensor sub-assembly and steering wheel assembly.

Refer to INSTALLATION [08/2020 - ]