LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> LC 500 >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Brake Control System - Service Information) >> Rear Speed Sensor >> Removal [04/2013 - 08/2015] >> Procedure

Removal [04/2013 - 08/2015]: Procedure

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2024 Lexus IS 500, 2024 Lexus IS 350, 2024 Lexus IS 300, 2023 Lexus IS 500, and 2023 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. PRECAUTION 
    NOTE:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Refer to PRECAUTION [04/2013 - 08/2015]

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [04/2013 - 06/2014] , or refer to INITIALIZATION [06/2014 - 08/2015]

  3. REMOVE LUGGAGE COMPARTMENT FLOOR MAT 

    Refer to PROCEDURE - Step 4

  4. REMOVE SPARE WHEEL COVER TRAY LH 

    Refer to PROCEDURE - Step 5

  5. REMOVE SPARE WHEEL COVER TRAY RH 

    Refer to PROCEDURE - Step 6

  6. REMOVE DECK SIDE TRIM BOX LH 

    Refer to PROCEDURE - Step 7

  7. REMOVE DECK SIDE TRIM BOX RH 

    Refer to PROCEDURE - Step 8

  8. REMOVE REAR LUGGAGE COMPARTMENT TRIM COVER 

    Refer to PROCEDURE - Step 9

  9. REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER (for Fixed Seat Type) 

    Refer to PROCEDURE - Step 10

  10. REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER (for Fold Down Seat Type) 

    Refer to PROCEDURE - Step 11

  11. SEPARATE LUGGAGE COMPARTMENT TRIM COVER 
    1. Disengage the 2 claws and open the cover.
      GTY465291Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt and rope hook assembly.
      GTY456525Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the 4 clips.
      GTY968766Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. for LH Side:
      1. Remove the clip (A).
    5. Separate the luggage compartment trim cover from the body.
  12. REMOVE REAR WHEEL 
  13. SEPARATE REAR WHEEL HOUSE LINER 
    1. Remove the 2 nuts and separate the rear wheel house liner.
      GTY468966Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  14. REMOVE REAR SPEED SENSOR 
    1. Turn back the luggage compartment trim cover until the rear speed sensor connector can be seen.
    2. Disengage the rear speed sensor connector.
      GTY463252Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *A for LH Side *B for RH Side
    3. Remove the 3 bolts and separate the rear speed sensor and 2 sensor clamps from the rear axle carrier sub-assembly and rear upper control arm assembly.
      GTY468946Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:
      • Prevent foreign matter from attaching to the rear speed sensor tip.
      • Clean the speed sensor installation hole and the contact surfaces every time the rear speed sensor is removed.
    4. Turn back the rear wheel house liner until the grommet can be disengaged.
    5. Remove the 2 nuts and 2 sensor clamps.
      GTY458045Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    6. Disengage the grommet and remove the rear speed sensor.
scientia non olet · About LEMON Manuals