LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> GS F >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Exterior Lights >> Automatic Headlight Beam Level Control System - Diagnostics - Introduction >> Automatic Headlight Beam Level Control System >> Freeze Frame Data [10/2015 - ] >> Freeze Frame Data [10/2015 - ]

Freeze Frame Data [10/2015 - ]

  1. FREEZE FRAME DATA 
    1. Whenever an automatic headlight beam level control system DTC is stored, the headlight control computer assembly LH stores the current vehicle state as freeze frame data.
  2. CHECK FREEZE FRAME DATA 
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / AFS / Trouble Codes.
    5. Select a DTC to display its freeze frame data.

      Body Electrical > AFS 

      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Traveling Direction Traveling direction Not Fwd: Shift lever in R or N Not Fwd: Shift lever in R or N
      Fwd: Shift lever not in R or N      		 -
      Headlight Low Beam State Low beam headlight state ON or OFF ON: Low beam headlights on
      OFF: Low beam headlights off      		 -
      Headlight High Beam State High beam headlight state ON or OFF ON: Low beam headlights on
      OFF: Low beam headlights off      		 -
      DRL State Daytime running light state ON or OFF ON: Daytime running lights on
      OFF: Daytime running lights off      		 -
      Clearance Light State Clearance light state ON or OFF ON: Clearance lights on
      OFF: Clearance lights off      		 -
      Right Cornering Light State Cornering light RH state ON or OFF ON: Cornering light RH on
      OFF: Cornering light RH off      		 -
      Left Cornering Light State Cornering light LH state ON or OFF ON: Cornering light LH on
      OFF: Cornering light LH off      		 -
      Engine Engine condition ON or OFF ON: Low beam headlights on
      OFF: Low beam headlights off      		 -
      Passing Light Switch Dimmer switch high flash position (pass) signal ON or OFF ON: Dimmer switch in high flash position
      OFF: Dimmer switch not in high flash position      		 -
      Steering Sens Signal Steering sensor signal value -384.0 deg to 382.5 deg 0.0 deg -
      FR Wheel Speed Front right wheel speed 0.00 to 327.67 km/h(203.60 mph) Vehicle stopped: 0 km/h (0 mph) -
      FL Wheel Speed Front left wheel speed 0.00 to 327.67 km/h(203.60 mph) Vehicle stopped: 0 km/h (0 mph) -
      Vehicle Acceleration Vehicle acceleration -455.64 to 445.60 m/s2 Vehicle stopped: 0.0 m/s2 -
      Leveling Motor Slave Status of the headlight leveling motor slave Normal or Abnormal Normal: Headlight leveling motor is normal
      Abnormal: Headlight leveling motor is not normal      		 If operation is abnormal, there may be a LIN communication error
      Leveling Motor Over-Run Status of the headlight leveling motor over-run Normal or Abnormal Normal: Headlight leveling motor is normal
      Abnormal: Headlight leveling motor is not normal      		 If operation is abnormal, there may be a LIN communication error
      +B Headlight ECU sub-assembly LH IG power supply voltage value 0 to 19.75 V 11.00 to 14.00 V -
      +B Voltage Value Headlight ECU sub-assembly LH +B power supply voltage value 0 to 19.75 V 11.00 to 14.00 V -
      Number Of Trouble Codes Number of stored DTCs when Freeze Frame Data stored 0 to 255 0 to 255 -
  3. CLEAR FREEZE FRAME DATA 
    NOTE:

    Clearing the DTCs will also clear the freeze frame data.

    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Clear the DTCs and freeze frame data.

      Refer to DTC CHECK / CLEAR [10/2015 - ] 

      Body Electrical > AFS > Clear DTCs 

scientia non olet · About LEMON Manuals