LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2019 >> UX 250h Base >> Repair and Diagnosis >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System / Washer System (Diagnostics - Introduction) >> Wiper And Washer System >> Freeze Frame Data [10/2018 - ] >> Freeze Frame Data [10/2018 - ]

Freeze Frame Data [10/2018 - ]

  1. FREEZE FRAME DATA 
    1. Whenever a DTC is detected, the windshield wiper motor assembly stores the current vehicle state as Freeze Frame Data.
  2. CHECK FREEZE FRAME DATA 
    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / Wiper / Trouble Codes.

      Body Electrical > Wiper > Trouble Codes 

      Body Electrical > Wiper 

      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Wiper Switch HI (Line) Front wiper switch HI position signal (direct line) OFF or ON OFF: Front wiper switch not in HI position
      ON: Front wiper switch in HI position      		 -
      Wiper Stop Position Windshield wiper motor assembly position Store Are/Lower Rev Pos, Wipe Area or Upper Rev Pos Store Are/Lower Rev Pos: Lower reverse position or lower
      Wipe Area: Between lower reverse position and upper reverse position
      Upper Rev Pos: Upper reverse position      		 -
      Wiper Position Windshield wiper motor assembly position Store Are, Exchange Position or Wipe Area Store Are: Out of wiper operating range
      Exchange Position: Within wiper maintenance position
      Wipe Area: Within wiper operating range      		 -
      Status of Motor Lock Windshield wiper motor assembly status Normal or Lock Normal: Operating normally
      Lock: Malfunctioning      		 -
      Status of Temperature Protection Windshield wiper motor assembly temperature protection Normal, LO Operation, INT Operation or Stop Normal: Windshield wiper motor assembly temperature is below 95°C (203°F)
      LO Operation: Windshield wiper motor assembly temperature is 95°C (203°F) or more
      INT Operation: Windshield wiper motor assembly temperature is 100°C (212°F) or more
      Stop: Windshield wiper motor assembly temperature is 105°C (221°F) or more      		 -
      Status of Overvoltage Windshield wiper motor assembly over voltage status Normal or Overvoltage Normal: Operating normally
      Overvoltage: Malfunctioning      		 -
      Status of Low Voltage Windshield wiper motor assembly low voltage status Normal or Low Voltage Normal: Operating normally
      Low voltage: Malfunctioning      		 -
      Motor Shaft Angle Windshield wiper motor assembly shaft angle status Min.: 0°
      Max.: 255°      		 Almost the same as actual windshield wiper motor assembly shaft angle -
      Motor Temperature Windshield wiper motor assembly temperature status Min.: -128°C (-198.4°F)
      Max.: 127°C (260.6°F)      		 Almost the same as actual windshield wiper motor assembly temperature -
      Motor Current Windshield wiper motor assembly current status Min.: 0 A
      Max.: 63 A      		 Almost the same as actual windshield wiper motor assembly current -
      Motor Power Supply Voltage Windshield wiper motor assembly voltage status Min.: 0 V
      Max.: 63 V      		 Almost the same as actual windshield wiper motor assembly voltage -
      Number of DTCs Number of trouble codes 0 to 255 Number of stored DTCs displayed -
scientia non olet · About LEMON Manuals