LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2019 >> UX 200 Base >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> Continuously Variable Transaxle (CVT) System (K120) (Diagnostic Codes) (2 Of 2) & Circuit Tests) >> Continuously Variable Transaxle System >> DTC U0129-87: Lost Communication With Brake System Control Module Missing Message [10/2018 - 07/2022] >> Procedure

DTC U0129-87: Lost Communication With Brake System Control Module Missing Message [10/2018 - 07/2022]: Procedure

  1. CLEAR DTC AND PERFORM ROAD TEST 
    1. Clear the DTCs.

      Powertrain > Transmission > Clear DTCs 

      HINT: 

      Write down the currently output DTCs before clearing them.

    2. Start the engine and drive the vehicle at a low speed.

      Result

      Proceed to
      NEXT

    Result: 

    NEXT 

    See step  2

  2. CHECK DTC OUTPUT (DTC U012987) 
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Powertrain / Transmission / Trouble Codes.

      Powertrain > Transmission > Trouble Codes 

    5. Read the DTCs using the Techstream.

      Result

      Result Proceed to
      DTC U012987 is not output A
      DTC U012987 is output B

    Result: 

    CHECK FOR INTERMITTENT PROBLEMS. Refer to  CHECK FOR INTERMITTENT PROBLEMS [10/2018 - 07/2022] 

    Result: 

    GO TO CAN COMMUNICATION SYSTEM. Refer to  DIAGNOSIS SYSTEM [10/2018 - 10/2019]  Refer to  DIAGNOSIS SYSTEM [10/2019 - 07/2022]