DTC P0607-47: Control Module Performance Bank 1 Watchdog/Safety MCU Failure [10/2018 - 07/2022]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Clear the DTCs.

   Powertrain > Transmission > Clear DTCs 

5. Turn the engine switch off.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  2

1. Disconnect the cable from the negative (-) auxiliary battery terminal and wait for 1 minute.
2. Connect the cable to the negative (-) auxiliary battery terminal.
3. Connect the Techstream to the DLC3.
4. Turn the engine switch on (IG).
5. Turn the Techstream on.
6. Wait for 1 second or more.
7. Enter the following menus: Powertrain / Transmission / Trouble Codes.
8. Read the DTCs.

   Powertrain > Transmission > Trouble Codes 

   Result

   Result	Proceed to
   DTCs are not output	A
   DTC P060747 is output	B

Result: 

A 

CHECK FOR INTERMITTENT PROBLEMS. Refer to  CHECK FOR INTERMITTENT PROBLEMS [10/2018 - 07/2022] 

Result: 

B 

See step  3

1. Replace the TCM.

   Refer to COMPONENTS [10/2018 - 07/2022]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

PERFORM REGISTRATION AND INITIALIZATION 

for Registration: Refer to REGISTRATION [10/2018 - 07/2022]

for Initialization: Refer to INITIALIZATION [10/2018 - 07/2022]