DTC P2182-11: Engine Coolant Temperature Sensor 2 Circuit Short to Ground [12/2017 - ]: Procedure

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Disconnect the engine coolant temperature sensor (for cylinder head side) connector.
2. Connect the Techstream to the DLC3.
3. Turn the engine switch on (IG).
4. Turn the Techstream on.
5. Enter the following menus: Powertrain / Engine / Data List / Coolant Temperature Sensor2.

   Powertrain > Engine > Data List 

   Tester Display
   Coolant Temperature Sensor2

6. According to the display on the Techstream, read the Data List.

   OK

   Techstream Display	Specified Condition
   Coolant Temperature Sensor2	-40°C (-40°F)

   HINT: 

   Perform "Inspection After Repair" after replacing the engine coolant temperature sensor (for cylinder head side).

   Refer to INITIALIZATION [12/2017 - 10/2020] , or refer to INITIALIZATION [10/2020 - 10/2023] , or refer to INITIALIZATION [10/2023 - ]

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE ENGINE COOLANT TEMPERATURE SENSOR (FOR CYLINDER HEAD SIDE). Refer to  REMOVAL [12/2017 - ] 

Result: 

NG 

See step  2

1. Disconnect the engine coolant temperature sensor (for cylinder head side) connector.
2. Disconnect the ECM connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   D20-2 (THW2) or D1-87 (THW2) - Body ground and other terminals	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE ECM. Refer to  REMOVAL [12/2017 - 09/2018]  , or refer to  REMOVAL [09/2018 - 10/2020]  , or refer to  REMOVAL [10/2020 - 10/2022]  , or refer to  REMOVAL [10/2022 - 10/2023]  , or refer to  REMOVAL [10/2023 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR