Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed, or replaced during the steering column assembly removal/installation are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replacement Part or Procedure | Necessary Procedure | Effect/Inoperative when not Performed | Link |
|---|---|---|---|
| Disconnect cable from negative battery terminal | Memorize steering angle neutral point | Parking assist monitor system | Refer to CALIBRATION [10/2015 - ] |
| Lane departure alert system (w/ Steering Control) | Refer to INITIALIZATION [10/2015 - ] | ||
| Pre-collision system | |||
| Reset power trunk lid | Power trunk lid system | Refer to INITIALIZATION [10/2015 - ] | |
| Removal/installation of the spiral cable with sensor sub-assembly | Steering angle neutral point (Initialize parking assist monitor system) | Parking assist monitor system | Refer to CALIBRATION [10/2015 - ] |
NOTE:
- Do not replace the spiral cable with sensor sub-assembly with the battery connected and the engine switch on (IG).
- Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly installed, with the battery connected and the engine switch on (IG).
- Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.