Distance Control Switch Circuit [10/2015 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Radar Cruise / Data List.
5. Read the Data List according to the display on the Techstream.

   Powertrain > Radar Cruise > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   Distance Control Switch	Distance control switch signal	ON or OFF	ON: Distance control switch on OFF: Distance control switch off	-

   Powertrain > Radar Cruise > Data List 

   Tester Display
   Distance Control Switch

   OK

   The Data List item shown in the table changes according to the operation of the steering pad switch assembly (distance control switch).

   Result

   Proceed to
   OK
   NG

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [10/2015 - 09/2017]  , or refer to  PROBLEM SYMPTOMS TABLE [09/2017 - ] 

Result: 

NG 

See step  2

1. Remove the steering pad switch assembly.

   Refer to REMOVAL [10/2015 - 09/2017] , or refer to REMOVAL [09/2017 - ]

2. Inspect the steering pad switch assembly.

   Refer to INSPECTION [10/2015 - 09/2017] , or refer to INSPECTION [09/2017 - ]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE STEERING PAD SWITCH ASSEMBLY. Refer to  REMOVAL [10/2015 - 09/2017]  , or refer to  REMOVAL [09/2017 - ] 

Result: 

OK 

See step  3

1. Remove the spiral cable with sensor sub-assembly.

   Refer to REMOVAL [10/2015 - 09/2017] , or refer to REMOVAL [09/2017 - ]

2. Inspect the spiral cable with sensor sub-assembly.

   Refer to INSPECTION [10/2015 - 09/2017] , or refer to INSPECTION [09/2017 - ]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY. Refer to  REMOVAL [10/2015 - 09/2017]  , or refer to  REMOVAL [09/2017 - ] 

Result: 

OK 

See step  4

1. Disconnect the K26 spiral cable with sensor sub-assembly connector.
2. Disconnect the K4 driving support ECU assembly connector.
3. Measure the resistance according to the value (s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   K26-12 (DIST) - K4-23 (SPSW)	Always	Below 1 Ω
   K26-2 (ECC) - Body ground	Always	Below 1 Ω
   K26-12 (DIST) or K4-23 (SPSW) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE DRIVING SUPPORT ECU ASSEMBLY. Refer to  REMOVAL [10/2015 - 09/2017]  , or refer to  REMOVAL [09/2017 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR