DTC C1AA0: Front Camera Module Circuit [10/2015 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Chassis / Front Recognition Camera / Trouble Codes.
5. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [10/2015 - ]

   Chassis > Front Recognition Camera > Clear DTCs 

6. Perform the following procedure.

   HINT: 

   If the following procedure is not performed, the previously output DTC cannot be detected.

   1. Turn the engine switch on (IG) and wait 2 seconds or more.
7. Check for DTCs.

   Refer to DTC CHECK / CLEAR [10/2015 - ]

   Chassis > Front Recognition Camera > Trouble Codes 

   Result

   Result	Proceed to
   DTC C1AA0 is not output	A
   DTC C1AA0 is output	B

Result: 

A 

USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [10/2015 - 09/2016]  , or refer to  HOW TO PROCEED WITH TROUBLESHOOTING [09/2016 - 09/2017]  , or refer to  HOW TO PROCEED WITH TROUBLESHOOTING [09/2017 - ] 

Result: 

B 

See step  2

1. Replace the forward recognition camera.

   Refer to REMOVAL [10/2015 - 09/2017] , or refer to REMOVAL [09/2017 - ]

2. Perform Forward Recognition Camera Learning.

   Refer to ADJUSTMENT [10/2015 - 09/2017] , or refer to ADJUSTMENT [09/2017 - ]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

END