DTC P0606-04: Control Module Processor System Internal Failure; DTC P060629: Control Module Processor Signal Invalid; DTC P060647: Control Module Processor Watchdog/Safety MCU Failure [10/2015 - ]: Procedure
WARNING: This page is about a different car, the 2019 Lexus GS 300, 2018 Lexus GS 300, 2017 Lexus GS 200t, and 2016 Lexus GS 200t. However, it is still accessible from the selected car via links, so may be relevant.
- READ OUTPUT DTC (DTC P060604, P060629 OR P060647)
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Clear the DTCs.
- Turn the engine switch off and turn the Techstream off.
- Disconnect the Techstream.
- Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
- Connect the cable to the negative (-) battery terminal.
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Wait 1 second or more.
- Enter the following menus: Powertrain / Engine / Trouble Codes.
- Read the DTCs.
Result
Result Proceed to DTCs are not output A DTC P060604, P060629 or P060647 is output B
Result:
A
CHECK FOR INTERMITTENT PROBLEMS. Refer to CHECK FOR INTERMITTENT PROBLEMS [10/2015 - ]
Result:
B
REPLACE ECM. Refer to REMOVAL [10/2015 - ]