Steering Pad Switch Circuit [12/2017 - 10/2020]: Procedure

1. Remove the steering pad switch assembly.

   Refer to REMOVAL [12/2017 - 09/2018] , or refer to REMOVAL [09/2018 - 10/2020]

2. Inspect the steering pad switch assembly.

   Refer to INSPECTION [12/2017 - 10/2023]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE STEERING PAD SWITCH ASSEMBLY. Refer to  REMOVAL [12/2017 - 09/2018]  , or refer to  REMOVAL [09/2018 - 10/2020] 

Result: 

OK 

See step  2

1. Remove the spiral with sensor cable sub-assembly.

   Refer to REMOVAL [12/2017 - 09/2018] , or refer to REMOVAL [09/2018 - 10/2020]

2. Inspect the spiral with sensor cable sub-assembly.

   Refer to INSPECTION [12/2017 - ]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY. Refer to  REMOVAL [12/2017 - 09/2018]  , or refer to  REMOVAL [09/2018 - 10/2020] 

Result: 

OK 

See step  3

1. Disconnect the G52 radio receiver assembly connector.
2. Disconnect the G27 spiral with sensor cable sub-assembly connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   G52-21 (SW1) - G27-12 (AU1)	Always	Below 1 Ω
   G52-22 (SW2) - G27-5 (AU2)	Always	Below 1 Ω
   G52-24 (SWG) - G27-4 (EAU)	Always	Below 1 Ω
   G52-21 (SW1) - Body ground	Always	10 kΩ or higher
   G52-22 (SW2) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [12/2017 - 09/2018]  , or refer to  PROBLEM SYMPTOMS TABLE [09/2018 - 10/2020] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR