Automatic ID Registration
NOTE:
Registration mode cannot be accessed if DTCs C2176/76, C2179/79 and U0129/29 are output. If DTCs C2176/76, C2179/79 and U0129/29 are output while work is being performed, registration mode will be canceled. Registration mode cannot be accessed while the ECU Data List is being displayed using the Techstream. If the ECU Data List is displayed using the Techstream while work is being performed, the registration mode will be canceled.
- Adjust the tire pressure in all tires to the specified pressure.
- Turn the engine switch OFF and stop the vehicle for 15 minutes or more.
- Turn the engine switch ON.
- Use the steering pad switch assembly, select "Change Wheel Set" on the multi-information display and press and hold the "ENTER" button until the tire pressure warning light blinks 3 times.
- Drive at approximately 23 mph (37 km/h) for approximately 10 to 30 minutes during 1 trip.
- During the procedure, make 2 or more right or left turns.
- When registration is completed, the tire pressure warning light turns off, the normal tire pressure is displayed on the multi-information display and "Registering Each TPWS Sensor" stops displaying
Registration may cancel or take longer than normal for the following reasons:
- Vehicle is often stopped
- Vehicle is stopped for long period of time
- Vehicle is driven in reverse
- Vehicle is driven parallel to another vehicle with the same type of tire pressure warning valve and transmitter installed for a long duration of time
- Vehicle was not stopped for 15 minutes or more before registration
- Vehicle was driven less than 23 mph (37 km/h) for a long duration of time
- The engine switch is turned OFF during ID registration