DTC P085D-94: Gear Shift Control Module "A" Unexpected Operation [03/2017 - 05/2023]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Enter the following menus: Powertrain / Transmission / Trouble Codes.

   Powertrain > Transmission > Trouble Codes 

4. Check for DTCs.

   Result

   Result	Proceed to
   None of the DTCs in the table below are output.	A
   Any of the DTCs in the table below are output.	B

   Priority	Relevant DTC
   1	U1107-00	Lost Communication with Power Management Module (Gear Shift Control Module "A")
   2	P0720-31	Output Speed Sensor No Signal
   	P0720-14	Output Speed Sensor Circuit Short to Ground or Open
   	P0720-12	Output Speed Sensor Circuit Short to Battery
   3	C1464	Front Speed Sensor RH Circuit
   	C1465	Front Speed Sensor LH Circuit
   	C1466	Rear Speed Sensor RH Circuit
   	C1467	Rear Speed Sensor LH Circuit

   HINT: 

   The chart above is listed in inspection order of priority.

5. Turn the engine switch off.

Result: 

B 

GO TO DTC CHART 

• for Electronic shift lever system:

  Refer to DIAGNOSTIC TROUBLE CODE CHART [03/2017 - 09/2018] , or refer to DIAGNOSTIC TROUBLE CODE CHART [09/2018 - 06/2019] , or refer to DIAGNOSTIC TROUBLE CODE CHART [06/2019 - 04/2020] , or refer to DIAGNOSTIC TROUBLE CODE CHART [04/2020 - 05/2023]

• for Automatic transmission system:

  Refer to DIAGNOSTIC TROUBLE CODE CHART [03/2017 - 09/2018] , or refer to DIAGNOSTIC TROUBLE CODE CHART [09/2018 - 06/2019] , or refer to DIAGNOSTIC TROUBLE CODE CHART [06/2019 - 05/2023]

• for Electronically controlled brake system:

  Refer to DIAGNOSTIC TROUBLE CODE CHART [03/2017 - 09/2018] , or refer to DIAGNOSTIC TROUBLE CODE CHART [09/2018 - 05/2023]

Result: 

A 

See step  2

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Enter the following menus: Powertrain / Transmission / Trouble Codes.

   Powertrain > Transmission > Trouble Codes 

4. Read the freeze frame data of DTC P085D-94.

   Powertrain > Transmission 

   Tester Display
   Vehicle Speed
   Speed (SP2)

   Result

   Result	Proceed to
   Vehicle was stopped ("Vehicle Speed" was between 0 and 1.4 km/h (0 and 1 mph)) but "Speed (SP2)" was 3 km/h (2 mph) or more	A
   Vehicle was stopped ("Vehicle Speed" was between 0 and 1.4 km/h (0 and 1 mph)) and "Speed (SP2)" was less than 3 km/h (2 mph)	B

5. Turn the engine switch off.

Result: 

B 

REPLACE SHIFT CONTROL ECU. Refer to  REMOVAL [03/2017 - 05/2023] 

Result: 

A 

See step  3

• for Front speed sensor:

  Refer to DTC C1464/31: Front Speed Sensor RH Circuit; DTC C1465/32: Front Speed Sensor LH Circuit [03/2017 - 09/2018] , or refer to DTC C1464: Front Speed Sensor RH Circuit; DTC C1465: Front Speed Sensor LH Circuit [09/2018 - ]

• for Rear speed sensor:

  Refer to DTC C1466/33: Rear Speed Sensor RH Circuit; DTC C1467/34: Rear Speed Sensor LH Circuit [03/2017 - 09/2018] , or refer to DTC C1466: Rear Speed Sensor RH Circuit; DTC C1467: Rear Speed Sensor LH Circuit [09/2018 - ]

Result

Result: 

OK 

REPLACE SHIFT CONTROL ECU. Refer to  REMOVAL [03/2017 - 05/2023] 

Result: 

NG 

REPAIR OR REPLACE MALFUNCTIONING PARTS