Steering Pad Switch Circuit (08/2016 -): Procedure

1. Disconnect the H97 radio receiver assembly connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   H97-30 (SW1) - H97-32 (SWG)	No switch pushed	95 to 105 kΩ
   	Seek+ switch pushed	Below 2.5 Ω
   	Seek- switch pushed	313 to 345 Ω
   	Volume+ switch pushed	950 to 1050 Ω
   	Volume- switch pushed	2955 to 3265 Ω
   H97-31 (SW2) - H97-32 (SWG)	No switch pushed	95 to 105 kΩ
   	MODE switch pushed	Below 2.5 Ω
   	On hook switch pushed	313 to 345 Ω
   	Off hook switch pushed	950 to 1050 Ω
   	Voice switch pushed	2955 to 3265 Ω

   Result

   Proceed to
   OK
   NG

Result:  1

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE (08/2016 -) 

Result:  2

NG 

See step  2

1. Remove the steering pad switch assembly.

   Refer to REMOVAL (07/2015 -)

2. Inspect the steering pad switch assembly.

   Refer to INSPECTION (08/2016 -)

   Result

   Proceed to
   OK
   NG

Result:  2

NG 

REPLACE STEERING PAD SWITCH ASSEMBLY. Refer to  REMOVAL (07/2015 -) 

Result:  1

OK 

See step  3

1. Remove the spiral cable with sensor sub-assembly.

   Refer to REMOVAL (08/2016 -)

2. Inspect the spiral cable with sensor sub-assembly.

   Refer to INSPECTION (08/2016 -)

   Result

   Proceed to
   OK
   NG

Result:  1

OK 

REPAIR OR REPLACE HARNESS OR CONNECTOR (RADIO RECEIVER ASSEMBLY - SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY) 

Result:  2

NG 

REPLACE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY. Refer to  REMOVAL (08/2016 -)