Millimeter Wave Radar Sensor Communication Stop Mode (07/2015 -): Procedure

1. Disconnect the cable from the negative (-) battery terminal.
2. Disconnect the A74 millimeter wave radar sensor assembly connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   A74-3 (CA2H) - A74-2 (CA2L)	Cable disconnected from negative (-) battery terminal	54 to 69 Ω

   TEXT IN ILLUSTRATION
   
   

   *a	Front view of wire harness connector (to Millimeter Wave Radar Sensor Assembly)

Result:  NG

NG 

REPAIR OR REPLACE CAN BRANCH LINE OR CONNECTOR (MILLIMETER WAVE RADAR SENSOR ASSEMBLY) 

Result:  OK

OK 

See step  2

1. Check the millimeter wave radar sensor assembly power source circuit (Refer to Millimeter Wave Radar Sensor Power Source Circuit (07/2015 -) ).

Result:  OK

OK 

REPLACE MILLIMETER WAVE RADAR SENSOR ASSEMBLY 

(Refer to REMOVAL (07/2015 -) )

Result:  NG

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)