Steering Pad Switch Circuit [08/2019 - ]: Procedure

1. Remove the steering pad switch assembly.

   Refer to REMOVAL [08/2019 - ]

2. Inspect the steering pad switch assembly.

   Refer to INSPECTION [08/2016 - ]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE STEERING PAD SWITCH ASSEMBLY. Refer to  REMOVAL [08/2019 - ] 

Result: 

OK 

See step  2

1. Remove the spiral cable sub-assembly.

   Refer to REMOVAL [08/2019 - ]

2. Inspect the spiral cable sub-assembly.

   Refer to INSPECTION [12/2017 - ]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE SPIRAL CABLE SUB-ASSEMBLY. Refer to  REMOVAL [08/2019 - ] 

Result: 

OK 

See step  3

1. Disconnect the U14 forward recognition camera connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   J29-12 (DIST) - U14-3 (LKSW)	Always	Below 1 Ω
   J29-12 (DIST) or U14-3 (LKSW) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  4

1. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   J29-2 (ECC) - Body ground	Always	Below 1 Ω

   Result

   Proceed to
   OK
   NG

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [08/2019 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR