DTC C1AB7: Blind Spot Monitor Slave Module [10/2015 - 08/2019]: Procedure

1. Turn the power switch off.
2. Turn the power switch on (IG).
3. Recheck for DTCs and check if the same DTC is output again.

   Body Electrical > Blind Spot Monitor Slave > Trouble Codes 

   OK

   No DTCs are output.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

USE SIMULATION METHOD TO CHECK.Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [10/2015 - 08/2016]  , or refer to  HOW TO PROCEED WITH TROUBLESHOOTING [08/2016 - 12/2017]  , or refer to  HOW TO PROCEED WITH TROUBLESHOOTING [12/2017 - 03/2018]  , or refer to  HOW TO PROCEED WITH TROUBLESHOOTING [03/2018 - 08/2019] 

Result: 

NG 

REPLACE BLIND SPOT MONITOR SENSOR RH.Refer to  REMOVAL [10/2015 - 08/2016]  , or refer to  REMOVAL [08/2016 - 03/2018]  , or refer to  REMOVAL [03/2018 - 08/2019]