LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2017 >> RX 350 Base, AWD >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Control System - Service Information >> Camshaft Position Sensor >> Removal [08/2019 - ] >> Procedure

Removal [08/2019 - ]: Procedure

  1. REMOVE INTAKE AIR SURGE TANK ASSEMBLY 

    Refer to REMOVAL [08/2019 - ]

  2. REMOVE VVT SENSOR (for Intake Side of Bank 1) 
    1. Disconnect the VVT sensor connector.
      GTY659089Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt and VVT sensor from the cylinder head cover sub-assembly.
      NOTE:

      If the VVT sensor has been struck or dropped, replace it.

  3. REMOVE VVT SENSOR (for Exhaust Side of Bank 1) 
    1. Disconnect the VVT sensor connector.
      GTY659088Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt and VVT sensor from the cylinder head cover sub-assembly.
      NOTE:

      If the VVT sensor has been struck or dropped, replace it.

  4. REMOVE VVT SENSOR (for Intake Side of Bank 2) 
    1. Disconnect the VVT sensor connector.
      GTY659000Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt and VVT sensor from the cylinder head cover sub-assembly LH.
      NOTE:

      If the VVT sensor has been struck or dropped, replace it.

  5. REMOVE VVT SENSOR (for Exhaust Side of Bank 2) 
    1. Disconnect the VVT sensor connector.
      GTY658999Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt and VVT sensor from the cylinder head cover sub-assembly LH.
      NOTE:

      If the VVT sensor has been struck or dropped, replace it.

scientia non olet · About LEMON Manuals