LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2017 >> RC 200t Base >> Repair and Diagnosis (Single Page) >> External Pages >> Different car >> Section 82 (Four Wheel Drive Control System - Diagnostics - Introduction) >> Four Wheel Drive Control System >> Initialization [09/2014 - ] >> Initialization [09/2014 - ]

Initialization [09/2014 - ]

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2024 Lexus RC 350, 2024 Lexus RC 300, 2023 Lexus RC 350, 2023 Lexus RC 300, and 2022 Lexus RC 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. DESCRIPTION 
    1. When the 4WD ECU assembly is replaced with a normal one from another vehicle, it is necessary to perform initialization.
      NOTE:
      • If initialization is not performed, it may affect AWD initial performance (acceleration, etc).
      • When the yaw rate sensor (G sensor) is replaced, it is necessary to perform initialization.

      HINT: 

      When the 4WD ECU assembly is replaced with a new one, it is not necessary to perform initialization.

  2. PERFORM INITIALIZATION 
    1. Turn the engine switch off.
    2. Connect the Techstream to the DLC3.
    3. Turn the engine switch on (IG).
    4. Turn the Techstream on.
    5. Enter the following menus: Chassis / Four Wheel Drive / Utility / Reset Memory.

      Chassis > Four Wheel Drive > Utility 

      Tester Display
      Reset Memory
    6. Operate the Techstream to clear the data.
scientia non olet · About LEMON Manuals