DTC P17A9: Transfer Shift Motor Control Circuit Low [09/2015 - ]: Procedure

1. Disconnect the A28 4 wheel drive control ECU connector.
2. Measure the resistance according to the value(s) in the table below.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Standard Resistance

   TRANSFER SHIFT ACTUATOR ASSEMBLY (HIGH-LOW TRANSFER SHIFT MOTOR) SIDE
   
   

   Tester Connection	Condition	Specified Condition
   A28-2 (HM1) or A28-6 (HM2) - Body ground	Always	10 kΩ or higher

   TRANSFER SHIFT ACTUATOR ASSEMBLY (CENTER DIFFERENTIAL LOCK SHIFT MOTOR) SIDE
   
   

   Tester Connection	Condition	Specified Condition
   A28-8 (TM1) or A28-7 (TM2) - Body ground	Always	10 kΩ or higher

   TEXT IN ILLUSTRATION
   
   

   * a	Front view of wire harness connector (to 4 Wheel Drive Control ECU)

   Result

   Result	Proceed to
   OK	A
   NG (transfer shift actuator assembly (high-low transfer shift motor) side)	B
   NG (transfer shift actuator assembly (center differential lock shift motor) side)	C

Result: 

A 

REPLACE 4 WHEEL DRIVE CONTROL ECU 

Refer to REMOVAL [09/2015 - ] )

Result: 

C 

See step  3

Result: 

B 

See step  2

1. Disconnect the A28 4 wheel drive control ECU connector.
2. Disconnect the C44 transfer shift actuator assembly connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   A28-2 (HM1) or C44-1 (HM1) - Body ground	Always	10 kΩ or higher
   A28-6 (HM2) or C44-2 (HM2) - Body ground	Always	10 kΩ or higher

Result: 

OK 

REPLACE TRANSFER SHIFT ACTUATOR ASSEMBLY 

Refer to DISASSEMBLY [09/2015 - ] )

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

1. Disconnect the A28 4 wheel drive control ECU connector.
2. Disconnect the C43 transfer shift actuator assembly connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   A28-8 (TM1) or C43-1 (TM1) - Body ground	Always	10 kΩ or higher
   A28-7 (TM2) or C43-2 (TM1) - Body ground	Always	10 kΩ or higher

Result: 

OK 

REPLACE TRANSFER SHIFT ACTUATOR ASSEMBLY 

Refer to DISASSEMBLY [09/2015 - ] )

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR