Inspection [09/2015 - ]: Procedure
- INSPECT SHIFT LOCK SOLENOID
- Measure the resistance according to the value(s) in the table below.
HINT:
Disconnect the solenoid connector.
Standard Resistance
Tester Connection Condition Specified Condition 3 (SLS-) - 4 (SLS+) Always 104 to 126 Ω If the result is not as specified, replace the transmission floor shift assembly.
- Measure the resistance according to the value(s) in the table below.
HINT:
Disconnect the solenoid connector.
Standard Resistance
Tester Connection Switch Condition Specified Condition 1 (P+) - 2 (P-) Parking position switch pushed 10 kΩ or higher 1 (P+) - 2 (P-) Parking position switch released Below 1 Ω If the result is not as specified, replace the transmission floor shift assembly.
- Measure the resistance according to the value(s) in the table below.