Removal [09/2015 - ]: Procedure
- REMOVE COWL TOP VENTILATOR LOUVER RH
Refer to PROCEDURE - Step 1
- PRECAUTION NOTE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Refer to PRECAUTION [09/2015 - ] ).
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [09/2015 - ] ).
- REMOVE ENGINE ROOM SIDE COVER RH
Refer to PROCEDURE - Step 7
- REMOVE FRONT FENDER UPPER PROTECTOR RH
Refer to PROCEDURE - Step 9
- REMOVE BATTERY
- REMOVE GROUND WIRE (BATTERY CURRENT SENSOR)
- Disconnect the connector.
- Remove the bolt and disconnect the ground wire harness from the ground wire (battery current sensor).
- Remove the 2 bolts and ground wire (battery current sensor).