DCM Data Signal Circuit between Navigation ECU and DCM [09/2015 - ]: Procedure

1. Disconnect the DCM (telematics transceiver) connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Disconnect the multi-media module receiver assembly connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   L157-1-1 (USB-) - L156-1-1 (USB-)	Always	Below 1 Ω
   L157-1-2 (USB+) - L156-1-2 (USB+)	Always	Below 1 Ω
   L157-1-3 (USBS) - L156-1-3 (USBS)	Always	Below 1 Ω
   L157-2 (USBG) - L156-2 (USBG)	Always	Below 1 Ω
   L157-3 (VOT+) - L156-7 (VOR+)	Always	Below 1 Ω
   L157-4 (USBV) - L156-4 (USBV)	Always	Below 1 Ω
   L157-5 (VOT-) - L156-6 (VOR-)	Always	Below 1 Ω
   L157-6 (VOR-) - L156-5 (VOT-)	Always	Below 1 Ω
   L157-7 (VOR+) - L156-3 (VOT+)	Always	Below 1 Ω
   L157-1-1 (USB-) - Body ground	Always	10 kΩ or higher
   L157-1-2 (USB+) - Body ground	Always	10 kΩ or higher
   L157-1-3 (USBS) - Body ground	Always	10 kΩ or higher
   L157-2 (USBG) - Body ground	Always	10 kΩ or higher
   L157-3 (VOT+) - Body ground	Always	10 kΩ or higher
   L157-4 (USBV) - Body ground	Always	10 kΩ or higher
   L157-5 (VOT-) - Body ground	Always	10 kΩ or higher
   L157-6 (VOR-) - Body ground	Always	10 kΩ or higher
   L157-7 (VOR+) - Body ground	Always	10 kΩ or higher

   TEXT IN ILLUSTRATION
   
   

   *a	Front view of wire harness connector (to DCM [Telematics Transceiver])
   *b	Front view of wire harness connector (to Multi-media Module Receiver Assembly)

Result:  OK

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE 

(Refer to PROBLEM SYMPTOMS TABLE [09/2015 - ] )

Result:  NG

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR