How To Proceed With Troubleshooting [09/2015 - ]: Procedure

Result

Result:  1

NEXT 

See step  2

Standard voltage

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding.

Result

Result:  1

NEXT 

See step  3

1. Use the Techstream to check if the CAN communication system is functioning normally.

   Result

   Result	Proceed to
   CAN DTC is not output	A
   CAN DTC is output	B

Result:  2

B 

GO TO CAN COMMUNICATION SYSTEM. Refer to  PRECAUTION [09/2015 - ] 

Result:  1

A 

See step  4

1. Use the Techstream to check if the LIN communication system is functioning normally.

   Result

   Result	Proceed to
   LIN DTC is not output	A
   LIN DTC is output	B

Result:  2

B 

GO TO LIN COMMUNICATION SYSTEM. Refer to  PRECAUTION [09/2015 - ] 

Result:  1

A 

See step  5

1. Check for DTCs. Based on the DTCs output above, try to cause the output of the same steering lock system DTC or engine immobiliser system DTC by simulating the symptoms indicated by the DTC.

   Result

   Result	Proceed to
   DTC output does not reoccur	A
   Steering lock system DTC output reoccurs	B
   Engine immobiliser system DTC output reoccurs	C

Result:  2

B 

GO TO STEERING LOCK SYSTEM. Refer to  PRECAUTION [09/2015 - ] 

Result:  3

C 

GO TO ENGINE IMMOBILISER SYSTEM. Refer to  PRECAUTION [09/2015 - ] 

Result:  1

A 

See step  6

Result

Result:  2

B 

See step  8

Result:  1

A 

See step  7

1. Operation Check

   Refer to OPERATION CHECK [09/2015 - ] 

2. Data List / Active Test

   Refer to DATA LIST / ACTIVE TEST [09/2015 - ] 

3. Terminals of ECU

   Refer to TERMINALS OF ECU [09/2015 - ] 

   Result

   Proceed to
   NEXT

Result:  1

NEXT 

See step  8

Result

Result:  1

NEXT 

See step  9

Result

Result:  1

NEXT 

END