LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2017 >> IS 350 Base, AWD >> Repair and Diagnosis >> Steering >> Steering Column >> Steering Column - Service Information >> Tilt And Telescopic Manual Switch >> Installation [10/2016 - ] >> Procedure

Installation [10/2016 - ]: Procedure

  1. INSTALL TILT AND TELESCOPIC SWITCH 
    1. Engage the claw to install the tilt and telescopic switch.
    2. Connect the tilt and telescopic connector to the tilt and telescopic switch.
    3. Connect the airbag connector to the spiral cable with sensor sub-assembly.
  2. INSTALL STEERING COLUMN COVER (for Lower Side) 
    1. Engage the 2 claws to install the steering column cover (lower).
    2. Install the 3 screws.
  3. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD 
  4. INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 6 [10/2016 - 09/2020] , or refer to PROCEDURE - Step 6 [09/2020 - ]

  5. INSTALL STEERING WHEEL ASSEMBLY 

    See step  9 [10/2016 - 11/2021], or see step  9 [11/2021 - ]

  6. CHECK STEERING WHEEL CENTER POINT 
  7. INSTALL HORN BUTTON ASSEMBLY 

    Refer to INSTALLATION [04/2013 - ]

  8. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM 

    See step  16 [10/2016 - 10/2017], or see step  16 [10/2017 - 09/2020], or see step  16 [09/2020 - 11/2021], or see step  17 [11/2021 - ]

scientia non olet · About LEMON Manuals