Power Source Circuit [10/2016 - 09/2020]: Procedure

1. Disconnect the Q50 blind spot monitor sensor LH connector.
2. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   Q50-5 (BLB) - Body ground	Engine switch on (IG)	11 to 14 V
   Q50-5 (BLB) - Body ground	Engine switch off	Below 1 V

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  2

1. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   Q50-10 (BLGD) - Body ground	Always	Below 1 Ω

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  3

1. Disconnect the Q51 blind spot monitor sensor RH connector.
2. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   Q51-5 (BRB) - Body ground	Engine switch on (IG)	11 to 14 V
   Q51-5 (BRB) - Body ground	Engine switch off	Below 1 V

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  4

1. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   Q51-10 (BRGD) - Body ground	Always	Below 1 Ω

   Result

   Proceed to
   OK
   NG

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [10/2016 - 10/2017]  , or refer to  PROBLEM SYMPTOMS TABLE [10/2017 - 09/2020] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR