LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2017 >> IS 350 Base, AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Can Communication System - Diagnostic Codes (1 Of 3) >> Can Communication System >> DTC U023A: Lost Communication with Front Camera Module [06/2014 - 10/2016] >> Procedure

DTC U023A: Lost Communication with Front Camera Module [06/2014 - 10/2016]: Procedure

  1. RECONFIRM DTC OUTPUT 
    1. Reconfirm DTCs.

      Body Electrical > Gateway > Trouble Codes 

      HINT: 

      If DTC U1002 is output from Gateway of the network gateway ECU, this indicates a sub bus 2 malfunction. Troubleshoot for DTC U1002 and check for malfunctions in sub bus 2.

      Result

      Result Proceed to
      DTC U1002 is not output from network gateway ECU (Techstream display: Gateway) A
      DTC U1002 is output from network gateway ECU (Techstream display: Gateway) B

    Result: 

    GO TO DIAGNOSIS PROCEDURE INDICATED BY OUTPUT DTC. Refer to  DTC U1002: Lost Communication with Gateway Module (Network Gateway ECU) [06/2014 - 10/2016] 

    Result: 

    See step  2

  2. CHECK FOR OPEN IN SUB BUS 2 LINES (LANE DEPARTURE WARNING CAMERA BRANCH LINE) 
    1. Disconnect the cable from the negative (-) battery terminal.
    2. Disconnect the S9 lane departure warning camera connector.
      GTY464055Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Front view of wire harness connector
      (to Lane Departure Warning Camera)
    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      S9-6 (CA1P) - S9-12 (CA1N) Cable disconnected from negative (-) battery terminal 54 to 69 Ω

      Result

      Result
      OK
      NG

    Result: 

    NG 

    REPAIR OR REPLACE CAN BRANCH LINE OR CONNECTOR (LANE DEPARTURE WARNING CAMERA) 

    Result: 

    OK 

    See step  3

  3. CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT) 
    1. Measure the resistance according to the value(s) in the table below.
      GTY464054Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Front view of wire harness connector
      (to Lane Departure Warning Camera)

      Standard Resistance

      Tester Connection Condition Specified Condition
      S9-11 (GND) - Body ground Cable disconnected from negative (-) battery terminal Below 1 Ω
    2. Reconnect the cable to the negative (-) battery terminal.
    3. Measure the voltage according to the value(s) in the table below.
      GTY470246Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Front view of wire harness connector
      (to Lane Departure Warning Camera)

      Standard Voltage

      Tester Connection Condition Specified Condition
      S9-7 (IGB) - Body ground Engine switch on (IG) 11 to 14 V

      Result

      Result
      OK
      NG

    Result: 

    OK 

    REPLACE LANE DEPARTURE WARNING CAMERA. Refer to  REMOVAL [04/2013 - 10/2016] 

    Result: 

    NG 

    REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)