Washer Fluid Level Warning Switch Circuit [08/2015 - 08/2019]: Procedure

1. Use the Data List to check if the level warning switch assembly is functioning properly (Refer to DATA LIST / ACTIVE TEST [08/2015 - 08/2019] ).
   COMBINATION METER
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Washer Switch	Level warning switch / ON or OFF	ON: Fluid volume is less than 550 to 750 cc (33.5 to 45.7 cu.in.) OFF: Fluid volume is more than 550 to 750 cc (33.5 to 45.7 cu.in.)	-

   OK

   On the Techstream screen, item changes between ON and OFF according to the above chart.

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE 

(Refer to PROBLEM SYMPTOMS TABLE [08/2015 - 08/2019] )

Result: 

NG 

See step  2

1. Remove the level warning switch assembly (Refer to REMOVAL [08/2015 - ] ).

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   1 - 2	Fluid volume is more than 830 cc (50.6 cu.in.)	10 kΩ or higher
   1 - 2	Fluid volume is less than 630 cc (38.4 cu.in.)	Below 1 Ω

   HINT: 

   When the fluid volume is between 630 and 830 cc (38.4 cu.in. and 50.6 cu.in.) the level warning switch may be on or off.

Result: 

NG 

REPLACE WASHER FLUID LEVEL WARNING SWITCH ASSEMBLY 

(Refer to REMOVAL [08/2015 - ] )

Result: 

OK 

See step  3

1. Disconnect the A20 and A washer wiring assembly connectors.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   A20-3 (S) - A-1	Always	Below 1 Ω
   A20-6 (E) - A-2	Always	Below 1 Ω
   A20-3 (S) - Body ground	Always	10 kΩ or higher
   A20-6 (E) - Body ground	Always	10 kΩ or higher

Result: 

NG 

REPLACE WASHER WIRING ASSEMBLY 

Result: 

OK 

See step  4

1. Disconnect the A20 washer wiring assembly connector.
2. Disconnect the G3 combination meter assembly connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   A20-3 (S) - G3-34 (WLVL)	Always	Below 1 Ω
   A20-6 (E) - Body ground	Always	Below 1 Ω
   A20-3 (S) - Body ground	Always	10 kΩ or higher

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY 

(Refer to REMOVAL [08/2015 - 08/2019] )

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR