DTC P0575: Cruise Control Input Circuit [08/2015 - 08/2019]: Procedure

1. Clear the DTCs (Refer to DTC CHECK / CLEAR [08/2015 - 08/2019] ).
2. Perform the following to make sure the DTC detection conditions are met.

   HINT: 

   If the detection conditions are not met, the system cannot detect the malfunction.

   1. Drive the vehicle at a speed of 50 km/h (30 mph) or more.
   2. Turn the cruise control switch on.
   3. Push the cruise control switch to -SET to activate cruise control.
3. Check for DTCs (Refer to DTC CHECK / CLEAR [08/2015 - 08/2019] ).

   OK

   DTC P0575 is not output.

Result: 

OK 

USE SIMULATION METHOD TO CHECK 

(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - 08/2019] )

Result: 

NG 

REPLACE ECM 

(Refer to REMOVAL [08/2015 - ] )