Caution / Notice / Hint

NOTE:

When using the Techstream with the engine switch off, perform either of the following: 1) Turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the Techstream and vehicle begins, or 2) connect the Techstream to the vehicle, select the vehicle type under manual mode, and then enter the following menus: Body Electrical / Smart Access / Trouble Codes.
The smart access system with push-button start uses multiplex communication. First perform the inspections in "How to Proceed with Troubleshooting" to confirm that there are no communication malfunctions before proceeding with troubleshooting (Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - 08/2019] ).
If the smart access system with push-button start is disabled through the customize function, enable the system before performing troubleshooting (Refer to CUSTOMIZE PARAMETERS [08/2015 - 08/2019] ).
Inspect the fuses of circuits related to this system before performing the following inspection procedure.
When replacing the steering lock actuator assembly (steering lock ECU), certification ECU or ID code box, registration must be performed (Refer to REGISTRATION [08/2015 - 08/2019] ).
If the steering lock actuator assembly (steering lock ECU) is replaced, be sure to confirm that the steering is unlocked by turning the steering wheel to the left and right before starting the engine. If the steering is locked for any reason, open and close a door with the engine switch off, and then unlock the steering by pressing the engine switch. This prevents the engine from starting while the steering is locked.
After completing repairs, confirm that the problem does not occur.

HINT:

RELATED DATA LIST AND ACTIVE TEST ITEMS

Problem Symptom	Data List Item	Active Test Item
Engine does not start	Power Source Control Stop Light Switch1 Steering Unlock Switch Power Supply Condition IG1 Relay Monitor(Inside) IG2 Relay Monitor(Inside) IG1 Relay Monitor(Outside) IG2 Relay Monitor(Outside) Latch Circuit Shift P Signal Neutral SW/ Clutch SW Starter Request Signal Smart Access S Code Check L Code Check Engine Start Request Power Supply Open Immobiliser Starting Control Ignition Starter SW Shift Position P or N	-

Problem Symptom

Data List Item

Active Test Item

Engine does not start

Power Source Control

Stop Light Switch1
Steering Unlock Switch
Power Supply Condition
IG1 Relay Monitor(Inside)
IG2 Relay Monitor(Inside)
IG1 Relay Monitor(Outside)
IG2 Relay Monitor(Outside)
Latch Circuit
Shift P Signal
Neutral SW/ Clutch SW
Starter Request Signal

Smart Access

S Code Check
L Code Check
Engine Start Request
Power Supply Open
Immobiliser

Starting Control

Ignition
Starter SW
Shift Position P or N

HINT:

If the brake pedal is repeatedly depressed while the engine is stopped, the brake booster pressure is released and the force required to depress the brake pedal to illuminate the stop lights increases.