Inspection [10/2015 - ]: Procedure

INSPECT COMBINATION SWITCH ASSEMBLY

Measure the resistance according to the value(s) in the table below.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Component without harness connected (Combination Switch Assembly)

Standard Resistance

Tester Connection	Switch Condition	Specified Condition
7 (P) - 4 (GND)	Mode switch being turned and held at SPORT position	Below 10 Ω
7 (P) - 4 (GND)	Mode switch not turned	10 kΩ or higher
3 (B) - 4 (GND)	Mode switch being pushed and held	Below 10 Ω
3 (B) - 4 (GND)	Mode switch not pushed	10 kΩ or higher
2 (2ND) - 4 (GND)	SNOW switch pushed and held	Below 10 Ω
2 (2ND) - 4 (GND)	SNOW switch not pushed	10 kΩ or higher

If the result is not as specified, replace the combination switch assembly.