DTC P011B: Engine Coolant Temperature / Intake Air Temperature Correlation [09/2014 - 09/2016]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
5. Read the DTCs.

   Result

   Result	Proceed to
   DTC P011B is output	A
   DTC P011B and other DTCs are output	B

   HINT: 

   If any DTCs other than P011B are output, troubleshoot those DTCs first.

Result:  B

B 

GO TO DTC CHART 

(See service information). Refer to DIAGNOSTIC TROUBLE CODE CHART [09/2014 - 10/2015] Refer to DIAGNOSTIC TROUBLE CODE CHART [10/2015 - 09/2016] )

Result:  A

A 

See step  2

1. Leave the vehicle for 7 hours or more.

   HINT: 

   It is necessary to leave the vehicle for 7 hours or more to allow conditions similar to the DTC detection conditions.

2. Connect the Techstream to the DLC3.
3. Turn the power switch on (IG).
4. Turn the Techstream on.
5. Enter the following menus: Powertrain / Engine and ECT / Data List / Intake Air.
6. Read the value displayed on the Techstream.

   OK

   Difference between the intake air temperature and the actual outside air temperature is within 10°C (18°F).

   HINT: 

   • Intake air temperature readings on the vehicle outside temperature gauge (if equipped) are not suitable for comparing to the intake air temperature reading. The outside temperature gauge has a significant delay built in to prevent temperature swings from being displayed on its display. Use an accurate thermometer to determine the outside air temperature.
   • Perform "Inspection After Repair" after replacing the mass air flow meter (See service information). Refer to INITIALIZATION [09/2014 - ] ).

Result:  NG

NG 

REPLACE MASS AIR FLOW METER 

(See service information). Refer to REMOVAL [09/2014 - ] )

Result:  OK

OK 

See step  3

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Engine and ECT / Data List / Coolant Temp.
5. Read the value displayed on the Techstream.

   OK

   Difference between the coolant temperature and the actual outside air temperature is within 10°C (18°F).

   HINT: 

   • If the result is not as specified, check if there are heat sources such as a block heater in the engine compartment.
   • Perform "Inspection After Repair" after replacing the engine coolant temperature sensor (See service information). Refer to INITIALIZATION [09/2014 - ] ).

Result:  OK

OK 

REPLACE ECM 

(See service information). Refer to REMOVAL [09/2014 - ] )

Result:  NG

NG 

REPLACE ENGINE COOLANT TEMPERATURE SENSOR 

(See service information). Refer to REMOVAL [09/2014 - ] )