LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2017 >> GS 350 Base, AWD >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Control System - Service Information >> Accelerator Pedal >> On-Vehicle Inspection [10/2015 - ] >> Procedure

On-Vehicle Inspection [10/2015 - ]: Procedure

  1. INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY 
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Powertrain / Engine and ECT / Data List / Accel Sensor Out No. 1 and Accel Sensor Out No. 2.
    5. When depressing or releasing the accelerator pedal, check that the values of the Accel Sensor Out No. 1 and Accel Sensor Out No. 2 are within the specification.

      Accel Sensor Out No. 1 Standard Voltage

      Condition Specified Condition
      Accelerator pedal is released 0.5 to 1.1 V
      Accelerator pedal is depressed 2.6 to 4.5 V

      Accel Sensor Out No. 2 Standard Voltage

      Condition Specified Condition
      Accelerator pedal is released 1.2 to 2.0 V
      Accelerator pedal is depressed 3.4 to 4.98 V

      If the result is not as specified, check the accelerator pedal sensor assembly, wire harness or ECM.

scientia non olet · About LEMON Manuals