LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2017 >> GS 200t Base >> Repair and Diagnosis (Single Page) >> Steering >> Manual Steering >> Variable Gear Ratio Steering System - Diagnostics - Introduction >> Variable Gear Ratio Steering System >> DTC Check / Clear [09/2014 - ] >> DTC Check / Clear [09/2014 - ]

DTC Check / Clear [09/2014 - ]

  1. CHECK DTC (Using Techstream) 
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Chassis / VGRS / Trouble Codes.
    5. Read the DTCs.
  2. CLEAR DTC (Using Techstream) 
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Chassis / VGRS / Trouble Codes.
    5. Clear the DTCs.
  3. CHECK DTC (Using SST Check Wire) 
    GTY651582Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    HINT: 

    The master warning light comes on in diagnostic mode.

    1. Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.
      • SST: 09843-18040 
      TEXT IN ILLUSTRATION

      *a Front view of DLC3
    2. Turn the engine switch on (IG).
    3. "DIAG VGRS" is displayed on the multi-information display and the system starts searching for a malfunction.
    4. If the system is normal, "DIAG VGRS FF" is displayed.
    5. If the system has a malfunction, "DIAG VGRS XX" is displayed ("XX" is a 2-digit DTC).
  4. CLEAR DTC (Using SST Check Wire) 
    GTY651582Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Turn the engine switch on (IG).
    2. Using SST, connect and disconnect terminals 13 (TC) and 4 (CG) of the DLC3 4 times within 8 seconds.
      • SST: 09843-18040 
      TEXT IN ILLUSTRATION

      *a Front view of DLC3
    3. Turn the engine switch off.

      HINT: 

      If a problem still exists, DTCs may not be cleared.

scientia non olet · About LEMON Manuals