Steering Pad Switch Circuit [09/2014 - 10/2015]: Procedure

1. Remove the steering pad switch assembly (Refer to REMOVAL [09/2014 - 10/2015] ).
2. Inspect the steering pad switch assembly (Refer to INSPECTION [09/2014 - 10/2015] ).

Result: 

NG 

REPLACE STEERING PAD SWITCH ASSEMBLY 

(Refer to REMOVAL [09/2014 - 10/2015] )

Result: 

OK 

See step  2

1. Remove the spiral with sensor cable sub-assembly (Refer to REMOVAL [09/2014 - 10/2015] ).
2. Inspect the spiral with sensor cable sub-assembly (Refer to INSPECTION [09/2014 - 09/2016] ).

Result: 

NG 

REPLACE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY 

(Refer to REMOVAL [09/2014 - 10/2015] )

Result: 

OK 

See step  3

1. Disconnect the N68 multi-media module receiver assembly connector.
2. Disconnect the N31 spiral with sensor cable sub-assembly connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Switch Condition	Specified Condition
   N68-30 (SW1) - N31-6 (AU1)	Always	Below 1 Ω
   N68-31 (SW2) - N31-5 (AU2)	Always	Below 1 Ω
   N68-32 (SWG) - N31-3 (EAU)	Always	Below 1 Ω
   N68-30 (SW1) - Body ground	Always	10 kΩ or higher
   N68-31 (SW2) - Body ground	Always	10 kΩ or higher
   N68-32 (SWG) - Body ground	Always	10 kΩ or higher

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE 

(Refer to PROBLEM SYMPTOMS TABLE [09/2014 - 09/2017] )

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR