DTC C1A63: Accelerator Pedal Position Sensor Circuit [07/2015 - ]: Procedure
- CHECK DTC OUTPUT (SFI SYSTEM)
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Engine and ECT / SFI system / Trouble Codes.
- Check for DTCs (Refer to DTC CHECK / CLEAR [07/2015 - ]
).RESULT
Result Proceed to SFI system DTCs are not output A SFI system DTCs are output B
Result: B
B
GO TO SFI SYSTEM
(Refer to DIAGNOSTIC TROUBLE CODE CHART [07/2015 - 08/2016] Refer to DIAGNOSTIC TROUBLE CODE CHART [08/2016 - ] )
Result: A
A
See step 2
- CHECK DTC OUTPUT (PRE-COLLISION SYSTEM)
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Pre-Collision 2 / Trouble Codes.
- Clear the DTCs (Refer to DTC CHECK / CLEAR [07/2015 - ] ).
- Make sure that the DTC detection conditions are met.
HINT:
If the detection conditions are not met, the system cannot detect the malfunction.
- Check for DTCs (Refer to DTC CHECK / CLEAR [07/2015 - ]
).RESULT
Result Proceed to DTC C1A63 is output A DTC C1A63 is not output B
Result: A
A
REPLACE DRIVING SUPPORT ECU ASSEMBLY
(Refer to COMPONENTS [07/2015 - ] )
Result: B
B
USE SIMULATION METHOD TO CHECK (SYMPTOM SIMULATION)
(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [07/2015 - ] )