Data List / Active Test [07/2015 - ]
- DATA LIST NOTE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Chassis / Advanced Parking Guidance/Parking Assist Monitor / Data List.
- Read the Data List according to the display on the Techstream.
ADVANCED PARKING GUIDANCE/PARKING ASSIST MONITORTester Display Measurement Item/Range Normal Condition Diagnostic Note Destination Data Check Verification of destination data/OK or NG OK: Data verification normal
NG: Data verification abnormal- EEPROM Status (Initial read) Rear television camera assembly information/OK or NG OK: Rear television camera assembly normal
NG: Rear television camera assembly abnormal- CPU Communication Status Rear television camera assembly information/OK or NG OK: Rear television camera assembly normal
NG: Rear television camera assembly abnormal- ASIC Output Status Output condition of video signal/OK or NG OK: Output condition of video signal normal
NG: Output condition of video signal abnormal- Wheel Speed Sensor (4wheel) Vehicle speed signal from speed sensor/OK or NG OK: Speed signal normal
NG: Speed signal abnormal- Parking Assist Function of Camera Rear television camera assembly condition/Valid or Invalid Valid: Rear television camera assembly operating
Invalid: Rear television camera assembly not operating- Number of DTC Number of stored trouble codes/min.: 0, max.: 255 Number of DTCs will be displayed - Current Key Cycle Cumulative number of times the engine switch was turned on/Min.: 0, Max.: 65535 time Cumulative number of times the engine switch was turned on will be displayed - Current Key Cycle Elapsed Time Time elapsed since the engine switch was turned on/Min.: 0, Max.: 1677721.5 s Time elapsed since the engine switch was turned on will be displayed -