DTC C1A63: Accelerator Pedal Position Sensor Circuit [07/2015 - ]: Procedure
- CHECK DTC OUTPUT (HYBRID CONTROL SYSTEM)
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
- Check for DTCs. Refer to DTC CHECK / CLEAR [07/2015 - ]RESULT
Result Proceed to Hybrid control system DTCs are not output A Hybrid control system DTCs are output B
Result: B
B
GO TO HYBRID CONTROL SYSTEM
Refer to HOW TO PROCEED WITH TROUBLESHOOTING [07/2015 - ]
Result: A
A
See step 2
- CHECK DTC OUTPUT (PRE-COLLISION SYSTEM)
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Pre-Collision 2 / Trouble Codes.
- Clear the DTCs. Refer to DTC CHECK / CLEAR [07/2015 - ]
- Make sure that the DTC detection conditions are met.
HINT:
If the detection conditions are not met, the system cannot detect the malfunction.
- Check for DTCs. Refer to DTC CHECK / CLEAR [07/2015 - ]RESULT
Result Proceed to DTC C1A63 is output A DTC C1A63 is not output B
Result: A
A
REPLACE DRIVING SUPPORT ECU ASSEMBLY
Refer to COMPONENTS [07/2015 - ]
Result: B
B
USE SIMULATION METHOD TO CHECK (SYMPTOM SIMULATION)