DTC P0106: Manifold Absolute Pressure / Barometric Pressure Circuit Range / Performance Problem [08/2014 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG) and turn the Techstream on.
3. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
4. Read the DTCs.
   RESULT
   
   

   Result	Proceed to
   DTC P0106 is output	A
   DTC P0106 and other DTCs are output	B

   HINT: 

   If any DTCs other than P0106 are output, troubleshoot those DTCs first.

Result:  B

B 

GO TO DTC CHART 

(See article. Refer to DIAGNOSTIC TROUBLE CODE CHART [08/2014 - 08/2015] Refer to DIAGNOSTIC TROUBLE CODE CHART [08/2015 - 06/2016] Refer to DIAGNOSTIC TROUBLE CODE CHART [06/2016 - ] )

Result:  A

A 

See step  2

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG) and turn the Techstream on.
3. Enter the following menus: Powertrain / Engine and ECT / Data List / Primary / MAP.
4. Read the MAP value at power switch on (IG).
5. Put the engine in inspection mode (maintenance mode) (See article. Refer to INSPECTION MODE PROCEDURE [08/2014 - ] ).
6. Start the engine and warm it up.
7. Read the MAP value at idling.

   Standard

   Engine condition	Techstream Display
   Power switch on (IG)	80 to 110 kPa(abs) [600 to 825 mmHg(abs)]
   Idling (not charge control)	28 to 48 kPa(abs) [210 to 360 mmHg(abs)]

Result:  OK

OK 

CHECK FOR INTERMITTENT PROBLEMS 

(See article. Refer to CHECK FOR INTERMITTENT PROBLEMS [08/2014 - ] )

Result:  NG

NG 

See step  3

1. Check the intake system for vacuum leaks (See article. Refer to ON-VEHICLE INSPECTION [08/2014 - ] ).

   OK

   No leaks in the intake system.

   HINT: 

   Perform "Inspection After Repair" after repairing or replacing the intake system (See article. Refer to INITIALIZATION [08/2014 - ] ).

Result:  OK

OK 

REPLACE MANIFOLD ABSOLUTE PRESSURE SENSOR 

(See article. Refer to REMOVAL [08/2014 - ] )

Result:  NG

NG 

REPAIR OR REPLACE INTAKE SYSTEM