DTC B2313: Glass Position Initialization Incomplete [08/2014 - ]: Procedure

1. Turn the power switch on (IG).
2. Initialize the power window regulator motor assembly (See article. Refer to INITIALIZATION [08/2014 - 08/2015] Refer to INITIALIZATION [08/2015 - ] ).

   HINT: 

   Initialize the power window regulator motor assembly that has DTC B2313 stored in its ECU.

Result:  NEXT

NEXT 

See step  2

1. Turn the power switch off.
2. Wait for at least 10 seconds, and then turn the power switch on (IG).
3. Check for DTCs (See article. Refer to DTC CHECK / CLEAR [08/2014 - ] ).

   HINT: 

   Check for DTCs for the power window regulator motor assembly that has DTC B2313 stored in its ECU.

   OK

   DTC B2313 is not output.

   Result

   Result	Proceed to
   OK	A
   NG (Driver door power window)	B
   NG (Front passenger side power window)	B
   NG (Rear LH side power window)	C
   NG (Rear RH side power window)	C

Result:  A

A 

END (POWER WINDOW CONTROL SYSTEM HAS NOT BEEN INITIALIZED) 

Result:  B

B 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Driver Side or Front Passenger Side) 

(See article. Refer to REMOVAL [08/2014 - ] )

Result:  C

C 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Rear LH Side or Rear RH Side) 

(See article. Refer to REMOVAL [08/2014 - ] )