Navigation Receiver Assembly Power Source Circuit [08/2014 - ]: Procedure

1. Disconnect the H140 radio receiver assembly connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   H140-12 (GND1) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   H140-17 (+B1) - H140-12 (GND1)	Power switch off	11 to 14 V
   H140-16 (ACC1) - H140-12 (GND1)	Power switch on (ACC)	11 to 14 V
   H140-15 (IG) - H140-12 (GND1)	Power switch on (IG)	11 to 14 V

Result:  OK

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE 

(See article. Refer to PROBLEM SYMPTOMS TABLE [08/2014 - ] )

Result:  NG

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR