DTC C1592/52: Actuator Neutral Position Calibration Incomplete [09/2014 - 09/2020]: Procedure

1. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [09/2014 - 09/2020]

   Chassis > VGRS > Clear DTCs 

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  2

1. Perform VGRS system calibration.

   Refer to CALIBRATION [09/2014 - 09/2020]

   Chassis > VGRS > Utility 

   Tester Display
   Steering Angle Adjust

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  3

1. Check for DTCs.

   Refer to DTC CHECK / CLEAR [09/2014 - 09/2020]

   Chassis > VGRS > Trouble Codes 

   Result

   Result	Proceed to
   DTC is not output	A
   DTC C15B2/72 is output	B
   DTC C1592/52 is output after VGRS system calibration has been performed 3 times or more	C

   NOTE:

   If DTC C1592/52 is output even though the VGRS system calibration has been performed, confirm the procedure again, and perform VGRS system calibration 3 times or more.

Result: 

A 

END 

Result: 

B 

REPLACE VGRS ECU (FRONT STEERING CONTROL ECU). Refer to  REMOVAL [09/2014 - ] 

Result: 

C 

REPLACE STEERING ACTUATOR ASSEMBLY. Refer to  REMOVAL [09/2014 - ]