LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2016 >> RC 300 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Lighting System (Ext) - Diagnostics - Introduction) >> Lighting System >> Data List / Active Test [10/2018 - 09/2020] >> Data List / Active Test [10/2018 - 09/2020]

Data List / Active Test [10/2018 - 09/2020]

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2024 Lexus RC 350, 2024 Lexus RC 300, 2023 Lexus RC 350, 2023 Lexus RC 300, and 2022 Lexus RC 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. DATA LIST 
    NOTE:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    HINT: 

    Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / (desired system) / Data List.
    5. Read the Data List according to the display on the Techstream.

      Body Electrical > Main Body > Data List 

      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Parking Brake SW Parking brake switch signal OFF or ON OFF: Parking brake switch off
      ON: Parking brake switch on      		 -
      Dimmer SW Dimmer switch high position signal OFF or ON OFF: Dimmer switch in low position
      ON: Dimmer switch in high or high flash position      		 -
      Passing Light SW Dimmer switch high flash position (pass) signal OFF or ON OFF: Dimmer switch not in high flash position
      ON: Dimmer switch in high flash position      		 -
      Rear Fog Light SW Fog light switch rear position signal OFF or ON OFF: Fog light switch off
      ON: Fog light switch in rear position      		 Although this item is displayed on the Techstream, it is not applicable to this vehicle.
      Auto Light SW Light control switch AUTO position signal OFF or ON OFF: Light control switch not in AUTO position
      ON: Light control switch in AUTO position      		 -
      Head Light SW (Head) Light control switch head position signal OFF or ON OFF: Light control switch not in head position
      ON: Light control switch in head position      		 -
      Head Light SW (Tail) Light control switch tail position signal OFF or ON OFF: Light control switch not in tail or head position
      ON: Light control switch in tail or head position      		 -
      Insolation Amount of Solar Sensor RH Solar sensor RH condition 0 to 51100 or Sensor Fail Condition can be displayed -
      Insolation Amount of Solar Sensor LH Solar sensor LH condition 0 to 51100 or Sensor Fail Condition can be displayed -
      Light Sensor Illuminance Light control sensor illuminance 0 to 8191 lx or Sensor Fail Value is output according to ambient light level -
      AUTO Light Status Auto light control operation status Not AUTO or AUTO Not AUTO: Automatic light control not operating
      AUTO: Automatic light control operating      		 -
      Light Sensor Connection Status Light control sensor connection status OFF or ON OFF: Automatic light control sensor has not been connected
      ON: Automatic light control sensor connected or has been connected      		 -
      Mirr-Foot-Lgt Approached/Exterior Light Approached Outside handle foot light controlled by actuation area-linked function OFF or ON Customize setting displayed -
      Mirr-Foot-Lgt Unlocked/Exterior Light Unlocked Outside handle foot light controlled by door unlock-linked function OFF or ON Customize setting displayed -
      Exterior Light (Door Open) Door open control function of the outside handle foot light control OFF or ON Customize setting displayed -
      Mirror Foot Light Time/Exterior Light Time Outside handle foot light lighting time 7.5 s, 15 s, 30 s or 0 s Customize setting displayed -
      Exterior Light Control Setting of the outside handle foot light control OFF or ON OFF or ON Customize setting displayed -
      Headlight Lighting Function ECU which controls the lighting system Main Body or Lighting Sys ECU Main Body: Lighting system controlled by main body ECU (multiplex network body ECU)
      Lighting Sys ECU: Lighting system is controlled by No. 1 headlight ECU sub-assembly LH      		 -
      Sensitivity Sensitivity of the automatic light control system Light2, Light1, Normal, Dark1 or Dark2 Customize setting displayed -
      DRL Function Setting of the DRL function OFF or ON OFF or ON Customize setting displayed w/ DRL OFF Switch
      Disp Ex ON Sen Ambient brightness level required to dim display lights (combination meter, navigation display, etc.) Light2, Light1, Normal, Dark1 or Dark2 Customize setting displayed -
      Disp Ex OFF Sen Ambient brightness level required to cancel dimming display lights (combination meter, navigation display, etc.) Light2, Light1, Normal, Dark1 or Dark2 Customize setting displayed -
      Light Auto OFF Delay Light auto OFF delay Off, 30 s, 60 s or 90 s Customize setting displayed -
      2 Steps Fade Out Control Function Setting of the 2 steps fade out control function OFF or ON OFF or ON Customize setting displayed -
      Light up Clearance Lights at Door Unlock Function Setting of the light up parking lights at door unlock function OFF or ON OFF or ON Customize setting displayed -
      The Number of DTC Number of trouble codes 0 to 255 Number of stored DTCs displayed -

      Body Electrical > HL AutoLeveling > Data List 

      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Headlight Low Beam State Low beam headlight state OFF or ON OFF: Low beam headlights off
      ON: Low beam headlights on      		 -
      Headlight High Beam State High beam headlight state OFF or ON OFF: High beam headlights off
      ON: High beam headlights on      		 -
      DRL Operating State Daytime running light state OFF or ON OFF: Daytime running lights off
      ON: Daytime running lights on      		 -
      Clearance Light State Parking light state OFF or ON OFF: Parking lights off
      ON: Parking lights on      		 -
      Right Cornering Light State Cornering light RH state OFF or ON OFF: Cornering light RH off
      ON: Cornering light RH on      		 -
      Left Cornering Light State Cornering light LH state OFF or ON OFF: Cornering light LH off
      ON: Cornering light LH on      		 -
      +B No. 1 headlight ECU sub-assembly LH IG power supply voltage value 0.00 to 19.75 V 11.00 to 14.00 V -
      Height Sens Pw Supply Val Rear height control sensor sub-assembly LH power supply value 0.00 to 5.00 V 4.61 to 5.00 V -
      Rr Height Sens Signal Val Rear height control sensor sub-assembly LH signal value 0.00 to 5.00 V 0.50 to 4.50 V Value changes according to vehicle height
      Front Right Wheel Speed Value Front right wheel speed 0.00 to 260.00 km/h (162.00 mph) Condition can be displayed -
      Front Left Wheel Speed Value Front left wheel speed 0.00 to 260.00 km/h (162.00 mph) Condition can be displayed -
      Vehicle Speed Vehicle speed 0.00 to 260.00 km/h (162.00 mph) Condition can be displayed -
      Rear Height Adjust Value Rear height adjustment off set value 0 to 1023 Actual rear height adjustment normal value is displayed (If there is a malfunction, no value is displayed) -
      Rear Height Adjust Valid Flag Rear height adjustment range Inval or Valid Inval: Rear height control sensor sub-assembly LH value out of normal range
      Valid: Rear height control sensor sub-assembly LH value within normal range      		 -
      Init Writing Count Number of times initialization performed 0 to 255 Number of times initialization performed -
      Sensor Initialization Hist Sensor initialization history not comp, 10%, 25%, 50%, 75%, 100% or complied not comp: No. 1 headlight ECU sub-assembly LH not initialized after replacing
      10%: Initialization completed when fuel tank was 10% full
      25%: Initialization completed when fuel tank was 25% full
      50%: Initialization completed when fuel tank was 50% full
      75%: Initialization completed when fuel tank was 75% full
      100%: Initialization completed when fuel tank was 100% full
      complied: ECU not replaced and ECU has not been initialized at workshop      		 -
      Steering Sensor Signal Steering angle sensor value -384.0 to 382.5 deg Changes according to the operation of the steering wheel -
      Steering Sensor Center Position Steering sensor center position -3072.0 to 3070.5 deg 0.0 deg -
      +B Voltage Value No. 1 headlight ECU sub-assembly LH IG power supply voltage value 0.00 to 19.75 V 11.00 to 14.00 V -
      Leveling Motor Target Position Headlight leveling motor target position 0.0 to 102.3 % 10 to 90 % -
      Number Of Trouble Codes Number of trouble codes 0 to 255 Number of stored DTCs displayed -

      Body Electrical > Combination Meter > Data List 

      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Turn Signal Switch (Right) Turn signal switch (right) signal OFF or ON OFF: Turn signal switch (right) off
      ON: Turn signal switch (right) on      		 -
      Turn Signal Switch (Left) Turn signal switch (left) signal OFF or ON OFF: Turn signal switch (left) off
      ON: Turn signal switch (left) on      		 -
      Hazard Flasher Switch Hazard warning signal switch signal OFF or ON OFF: Hazard warning signal switch off
      ON: Hazard warning signal switch on      		 -
  2. ACTIVE TEST 

    HINT: 

    Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / (desired system) / Active Test.
    5. Perform the Active Test according to the display on the Techstream.

      Body Electrical > Main Body > Active Test 

      Tester Display Measurement Item Control Range Diagnostic Note
      Daytime Running Light Daytime running lights OFF or ON -
      Exterior Light Outside handle foot lights OFF or ON -
      Taillight Relay Taillight relay OFF or ON -
      Headlight Relay Low beam headlights OFF or ON -
      Head Light Hi High beam headlights OFF or ON -
      Rear Fog Light Relay Rear Fog Lights OFF or ON Although this item is displayed on the Techstream, it is not applicable to this vehicle.
      Dimmer Signal Dimmer signal OFF or ON State where circumference illumination is bright

      Body Electrical > HL AutoLeveling > Active Test 

      Tester Display Measurement Item Control Range Diagnostic Note
      Clearance Light Parking lights OFF or ON -
      Headlight Low Beam Low beam headlights OFF or ON -
      Headlight High Beam High beam headlights OFF or ON -
      Daytime Running Light Daytime running lights OFF or ON -
      Cornering Light Cornering lights OFF or ON -
      Headlight Indicator "Headlight System Malfunction Visit Your Dealer" display OFF or ON -
scientia non olet · About LEMON Manuals