LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2016 >> LS 600h >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Control System - Service Information >> Engine Coolant Temperature Sensor >> Inspection [09/2015 - ] >> Procedure

Inspection [09/2015 - ]: Procedure

  1. INSPECT ENGINE COOLANT TEMPERATURE SENSOR 
    GTY668129Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Partially immerse the sensor in water and warm up the water.
    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      1 - 2 Approximately 20°C (68°F) 2.32 to 2.59 kΩ
      1 - 2 Approximately 80°C (176°F) 0.310 to 0.326 kΩ

      If the result is not as specified, replace the engine coolant temperature sensor.

      HINT: 

      If the result is as specified, it is not necessary to replace the engine coolant temperature sensor.

      NOTE:

      When checking the engine coolant temperature sensor in water, keep the terminals dry. After the check, wipe the engine coolant temperature sensor dry.

scientia non olet · About LEMON Manuals