LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2016 >> LS 600h >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Anti-Theft Systems >> Smart Access System (Keyless Entry) (Diagnostics & Symptom Tests) >> Smart Access System With Push-Button Start >> How To Proceed With Troubleshooting [09/2015 - ] >> Procedure

How To Proceed With Troubleshooting [09/2015 - ]: Procedure

  1. VEHICLE BROUGHT TO WORKSHOP 

    Result

    Proceed to
    NEXT

    Result:  1

    NEXT 

    See step  2

  2. INSPECT AUXILIARY BATTERY VOLTAGE 

    Standard voltage

    11 to 14 V

    If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding.

    Result

    Proceed to
    NEXT

    Result:  1

    NEXT 

    See step  3

  3. INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* 
    1. Use the Techstream to check if the CAN communication system is functioning normally.

      Refer to DIAGNOSIS SYSTEM [09/2015 - ]

      Result

      Result Proceed to
      CAN DTC is not output A
      CAN DTC is output B

    Result:  2

    GO TO CAN COMMUNICATION SYSTEM. Refer to  PRECAUTION [09/2015 - ] 

    Result:  1

    See step  4

  4. INSPECT COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM* 
    1. Use the Techstream to check if the LIN communication system is functioning normally.

      Result

      Result Proceed to
      LIN DTC is not output A
      LIN DTC is output B

    Result:  2

    GO TO LIN COMMUNICATION SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [09/2015 - ] 

    Result:  1

    See step  5

  5. CHECK FOR DTC* 
    1. Check for DTCs. Based on the DTCs output above, try to cause the output of the same steering lock system DTC or engine immobiliser system DTC by simulating the symptoms indicated by the DTC.

      Result

      Result Proceed to
      DTC is not output A
      Steering lock system DTC is output B
      Engine immobiliser system DTC is output C

    Result:  2

    GO TO STEERING LOCK SYSTEM. Refer to  PRECAUTION [09/2015 - ] 

    Result:  3

    GO TO ENGINE IMMOBILISER SYSTEM. Refer to  PRECAUTION [09/2015 - ] 

    Result:  1

    See step  6

  6. PROBLEM SYMPTOMS TABLE 
    1. Refer to the problem symptoms table.

      Refer to PROBLEM SYMPTOMS TABLE [09/2015 - ] 

      Result

      Result Proceed to
      Fault is not listed in problem symptoms table A
      Fault is listed in problem symptoms table B

    Result:  2

    See step  8

    Result:  1

    See step  7

  7. OVERALL ANALYSIS AND TROUBLESHOOTING* 
    1. Operation check

      Refer to OPERATION CHECK [09/2015 - ] 

    2. Data List /Active Test

      Refer to DATA LIST / ACTIVE TEST [09/2015 - ] 

    3. Terminals of ECU

      Refer to TERMINALS OF ECU [09/2015 - ] 

      Result

      Proceed to
      NEXT

    Result:  1

    NEXT 

    See step  8

  8. REPAIR OR REPLACEMENT 

    Result

    Proceed to
    NEXT

    Result:  1

    NEXT 

    See step  9

  9. CONFIRMATION TEST 

    Result

    Proceed to
    NEXT

    Result:  1

    NEXT 

    END