LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2016 >> LS 460 Base, AWD >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Control System - Service Information >> Accelerator Pedal >> On-Vehicle Inspection [09/2015 - ] >> Procedure

On-Vehicle Inspection [09/2015 - ]: Procedure

  1. INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY 
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the tester on.
    4. Enter the following menus: Powertrain / Engine / Data List / ETCS / Accel Sensor Out No. 1 and Accel Sensor Out No. 2.
    5. Read the value displayed on the tester.

      Accel Sensor Out No. 1 Standard Voltage

      Condition Specified Condition
      Accelerator pedal is released 0.5 to 1.1 V
      Accelerator pedal is depressed 2.6 to 4.5 V

      Accel Sensor Out No. 2 Standard Voltage

      Condition Specified Condition
      Accelerator pedal is released 1.2 to 2.0 V
      Accelerator pedal is depressed 3.4 to 4.75 V

      If the result is not as specified, check the accelerator pedal sensor assembly, wire harness or ECM.

scientia non olet · About LEMON Manuals